Skip to content
Insignias Full Models Conv.Kits Marines Head Swaps Weapons Shields Vehicle Parts Walkers Apparel
Iron Wolf - Wolf Conversion Kit

Iron Wolf - Wolf Conversion Kit

€56,95 - €56,95
€56,95
€56,95 - €56,95
€56,95

The Iron Wolf Conversion Kit is a comprehensive bundle of components specifically for Questor Class Knights, which include:
- Iron Wolf Head
- Iron Wolf Shoulder Pad (Right)
- Iron Wolf Shoulder Pad (Left)
- Iron Wolf Frost Cannon
- A set of Iron Wolf Knee Pads
- Pair of Iron Wolf Feet

Attaching Instructions for head
1) Glue the wire bundle to the section where the head is normally attached.
2) I have designed the head to swivel, and be removable by using small magnets.
3) I have included the link to these magnets here. Two of these small 3mm magnets are required.
4) The two small pipes that normally link to the front of the skull head can be glued onto this replacement head instead.
5) You can also glue the head in place and skip the magnets completely, though it WILL NOT rotate.

Attaching Instructions for Cannon
Assemble the Cannon where the stock long range weapon is meant to fit.

Attaching Instructions for Knee Pads
Assemble the knee pads in the location where the stock knee pads typically fit.

Attaching instructions for Feet:
There is a LEFT and RIGHT foot, and are identified with the letters L and R in the piece's sockets. Each should be glued in place of the stock feet so the toes point slightly outward. 

Attaching Instructions for Left & Right Shoulder Pads:
The shoulder pad fits on the right and left side of the model respectively, where the stock shoulder pad is meant to fit.

These parts have been designed by Iron Wolf Minis, and have been licensed for a limited time, to Pop Goes the Monkey.

Monkey Resin 3 is a high-quality, UV-cured resin designed for strength, impact resistance, and precise detail reproduction. Its low shrinkage rate prevents distortion or loss of fine features while providing a refined surface with stunning details.

These parts will arrive attached to their support structure, ensuring all components remain secure during transportation. Most parts can be easily removed by hand; however, if you soak them in hot tap water for 5 minutes, they will come off much easier. Some attachments may require snippers or a hobby knife for a cleaner detachment. Please make sure you use sharp tools carefully to avoid injury. Once removed, all products are pre-cleaned and ready for primer and paint. Use only super glue to adhere these parts to your models.

 

*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates.  This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC.  Please see our full Terms of Service for more information.