Skip to content
Insignias Full Models Conv.Kits Marines Head Swaps Weapons Shields Vehicle Parts Walkers Apparel
Standard : Eternus Assault Armor kit

Standard : Eternus Assault Armor kit

€63,95 - €63,95
€63,95
€63,95 - €63,95
€63,95

The Eternus Assault Armor is a Multipart, Magnet-Ready kit designed for flex-ability and customization. Fully assembled it stands 7cm tall (about 3-1/2") and is a comparable size to a Contemptor Dreadnought*. It can be assembled in a wide range of poses with many customization including 4 head options. Its arms and weapons come pre-drilled for magnets to make them interchangeable for future-proofing your miniature.

This kit comes with multiple options for the head and armor details, Right & Left underslung weapon hands , missile launcher and… 

  • Left hand Powered Claws & Fits with wrist weapons
  • 1 Beam Cannon
  • 1 Plasma Cannon
  • 1 Laser Cannon
  • 1 Stud Cannon
  • 1 Heat Ray Cannon
  • 1 Thermal Cannon
  • 1 Repeating Cannon
  • 1 Gatling Cannon

This kit is Licensed, for a limited time, to Pop Goes the Monkey from the digital artist, Antonis Bouras. If you would like to purchase this .stl file or see what he's working on next [click here]. 

Assembly Instructions can be found at this link. To assemble the Eternus Assault Armor with magnets for switching weapons you will need the following sizes (all measurements are diameter x depth):

  • Elbow Joints: top arm 1/4" x 1/16", bottom arm 1/4 x 1/32" per arm
  • Wrist Joints require two 1/4" x 1/32" per arm
  • Top Missile Launcher requires two 1/8" x 1/16" magnets
  • Each Weapon will require a 1/4" x 1/16" and a 1/4" x 1/32" magnet along with two smaller 1/8" x 1/16" and 1/8" x 1/32" magnets to prevent torquing.

The kit also comes with two plugs to use for elbow joints if you decide to assemble your Eternus without any magnets as well. A base is not included, but we recommend our 60mm Round base options.

 

Monkey Resin 3 is a high-quality, UV-cured resin designed for strength, impact resistance, and precise detail reproduction. Its low shrinkage rate prevents distortion or loss of fine features while providing a refined surface with stunning details.

These parts will arrive attached to their support structure, ensuring all components remain secure during transportation. Most parts can be easily removed by hand; however, if you soak them in hot tap water for 5 minutes, they will come off much easier. Some attachments may require snippers or a hobby knife for a cleaner detachment. Please make sure you use sharp tools carefully to avoid injury. Once removed, all products are pre-cleaned and ready for primer and paint. Use only super glue to adhere these parts to your models.


*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates.  This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC.  Please see our full Terms of Service for more information.