![Anger Cannon (Right): Blight Shroud Terminator](http://popgoesthemonkey.com/cdn/shop/products/1MG-BST21013-M_900x636.png?v=1610647944)
Anger Cannon (Right): Blight Shroud Terminator
Original price
¥1,400
-
Original price
¥1,400
Original price
¥1,400
¥1,400
-
¥1,400
Current price
¥1,400
This weapon bit is designed to fit with our Blight Shroud Terminator models. They were designed and sculpted by the free-blade artist, KarnageKing. These part do not come with the terminator body. Those are sold separately.
Monkey Resin is a high-quality UV cured resin that will come attached to a support structure from the production process. The parts are however, pre-cleaned and ready for primer once removed. Use only super glue to adhere these parts to your models.
To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports all together.
You can use a very fine-grit sandpaper if needed to smooth any surface or feature further. Always be sure to wear a mask when working around resin dust.
*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.
Monkey Resin is a high-quality UV cured resin that will come attached to a support structure from the production process. The parts are however, pre-cleaned and ready for primer once removed. Use only super glue to adhere these parts to your models.
To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports all together.
You can use a very fine-grit sandpaper if needed to smooth any surface or feature further. Always be sure to wear a mask when working around resin dust.
*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.