Skip to content

Country

Monkey Resin™ Instructions

Working with Monkey Resin™ is simple. 

The first step, is to remove your bits from their supports structure. To do this easily, submerge the whole assembly into water that is hot to the touch, but not boiling, for five minutes. 

After the parts have soaked in the hot water, it should be pliable and allow you to use your fingernail to punch away several supports under your products. This will create a starting point to then carefully peel your parts off of the remaining supports all together.

Some smaller bits will require you to carefully clip each bit off their sprue and supports individually. Snips are suggested for this procedure.

After its been removed, treat this product just like you would any other resin product. 

You can use a very fine-grit sandpaper to smooth any surface or feature further. Always be sure to wear a mask when working around resin dust.

Use Super Glue (not plastic glue) to adhere these parts to your models.