Egyptian Knight - Anubis Head
The Egyptian Knight Anubis Head replaces the stock face mask, robot skull head, and cowl. This accessory component is compatible with Questor and Dominion class Knights.
Attaching Instructions
1) Glue the wire bundle to the section where the head is normally attached.
2) I have designed the head to swivel, and be removable by using small magnets.
3) I have included the link to these magnets here. Two of these small 3mm magnets are required.
4) The two small pipes that normally link to the front of the skull head can be glued onto this replacement head instead.
5) You can also glue the head in place and skip the magnets completely, though it WILL NOT rotate.
These parts have been designed by Iron Wolf Minis, and have been licensed for a limited time, to Pop Goes the Monkey.
Monkey Resin 3 is a high-quality, UV-cured resin designed for strength, impact resistance, and precise detail reproduction. Its low shrinkage rate prevents distortion or loss of fine features while providing a refined surface with stunning details.
These parts will arrive attached to their support structure, ensuring all components remain secure during transportation. Most parts can be easily removed by hand; however, if you soak them in hot tap water for 5 minutes, they will come off much easier. Some attachments may require snippers or a hobby knife for a cleaner detachment. Please make sure you use sharp tools carefully to avoid injury. Once removed, all products are pre-cleaned and ready for primer and paint. Use only super glue to adhere these parts to your models.
TufFlex MJP is another Monkey-Jet material with a smooth surface and an extremely high level of detail. However, it's formulated for improved toughness and flexibility to provide a bend-but-don't-break strategy of protection for your models. Thin parts may arrive slightly warped but, can be easily re-shaped by warming them up to be bent back into shape. This can also be an added benefit if you're looking to glue a flat logo onto a curved surface. At room temperature parts will flex but, they can be brittle at much lower temperatures. Use super glue to adhere these parts to your models.
*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.
