Mori Tempus - Prime:1 PACs Squad 1 (w/Mag.Vex)
Original price
¥5,400
-
Original price
¥6,100
Original price
¥5,400
¥5,400
-
¥6,100
Current price
¥5,400
The Prime:1 PACs (Personal Atomic Cores) are designed for the new, bigger “Prime” Marine models. This Squad Set includes a Comms PAC and a Banner-Ready Pack that utilizes two, 1/16" x 1/8" (2mm x 3mm) Cylinder Magnets, to affix the Vexilla banner to the backpack. This system allows you to remove the banner for safe transportation and storage, as well as allowing it to “give a little” instead of breaking if handled roughly.
These magnets can be found on many retailers online but, I recommend my friends over at the Magnet Barron .
Classic MJP is an acrylic material printed using Monkey-Jet technology, which is capable of extremely high detailed parts with a smooth finish. This technique uses wax to support the printing parts to allow for any geometry to be printed without the need of printed supports. Its color may range from amber to clear and parts can be brittle so, handle with care. This material will NOT react with Plastic Glue so, we recommend using Super Glue to adhere these parts to your models.
TufFlex MJP is another Monkey-Jet material with a smooth surface and an extremely high level of detail. However, it's formulated for improved toughness and flexibility to provide a bend-but-don't-break strategy of protection for your models. Thin parts may arrive slightly warped but, can be easily re-shaped by warming them up to be bent back into shape. This can also be an added benefit if you're looking to glue a flat logo onto a curved surface. At room temperature parts will flex but, they can be brittle at much lower temperatures. Use super glue to adhere these parts to your models.
*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.
These magnets can be found on many retailers online but, I recommend my friends over at the Magnet Barron .
Classic MJP is an acrylic material printed using Monkey-Jet technology, which is capable of extremely high detailed parts with a smooth finish. This technique uses wax to support the printing parts to allow for any geometry to be printed without the need of printed supports. Its color may range from amber to clear and parts can be brittle so, handle with care. This material will NOT react with Plastic Glue so, we recommend using Super Glue to adhere these parts to your models.
TufFlex MJP is another Monkey-Jet material with a smooth surface and an extremely high level of detail. However, it's formulated for improved toughness and flexibility to provide a bend-but-don't-break strategy of protection for your models. Thin parts may arrive slightly warped but, can be easily re-shaped by warming them up to be bent back into shape. This can also be an added benefit if you're looking to glue a flat logo onto a curved surface. At room temperature parts will flex but, they can be brittle at much lower temperatures. Use super glue to adhere these parts to your models.
*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.