Skip to content
Insignias Full Models Conv.Kits Marines Head Swaps Weapons Shields Vehicle Parts Walkers Apparel
Iron Wolf - Armadillo : Squire Carapace
Iron Wolf - Armadillo : Squire Carapace
Iron Wolf - Armadillo : Squire Carapace
Iron Wolf - Armadillo : Squire Carapace
Iron Wolf - Armadillo : Squire Carapace

Iron Wolf - Armadillo : Squire Carapace

¥2,300 - ¥3,700
¥2,300
¥2,300 - ¥3,700
¥2,300

Our customers have found these accessory components are compatible with Armiger class Knights. This armored carapace replaces the stock carapace included with the kit.

Attaching Instructions
1) Butt the carapace up against the back of the stock cowl for best alignment.
2) Center the armor side-to-side on top of the main body, and then glue it into position.
3) Glue the shoulder pads and gun into place on top of the carapace.

These parts have been designed by Iron Wolf Minis, and have been licensed for a limited time, to Pop Goes the Monkey.

 

Monkey Resin 3 is a high-quality, UV-cured resin designed for strength, impact resistance, and precise detail reproduction. Its low shrinkage rate prevents distortion or loss of fine features while providing a refined surface with stunning details.

These parts will arrive attached to their support structure, ensuring all components remain secure during transportation. Most parts can be easily removed by hand; however, if you soak them in hot tap water for 5 minutes, they will come off much easier. Some attachments may require snippers or a hobby knife for a cleaner detachment. Please make sure you use sharp tools carefully to avoid injury. Once removed, all products are pre-cleaned and ready for primer and paint. Use only super glue to adhere these parts to your models.

TufFlex MJP is another Monkey-Jet material with a smooth surface and an extremely high level of detail. However, it's formulated for improved toughness and flexibility to provide a bend-but-don't-break strategy of protection for your models. Thin parts may arrive slightly warped but, can be easily re-shaped by warming them up to be bent back into shape. This can also be an added benefit if you're looking to glue a flat logo onto a curved surface. At room temperature parts will flex but, they can be brittle at much lower temperatures. Use super glue to adhere these parts to your models.


*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates.  This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC.  Please see our full Terms of Service for more information.