Kings Fist 2 - Marine Boarding Shields
The Marine Boarding shields are all left-handed, allowing your favorite 28mm marine models to interlock into a reinforced wall of firepower. These were designed for the classic marine models, but I've been told they still work great for the new 30k scale. You may find them a bit too small for the larger "Prime" models.
The shields include the hand and part of the forearm that is holding it, so adding them to your models requires only a minor amount of hobby skill. Simply snip off most of the model's left forearm, just short of the elbow at the pitch or angle you prefer. They are sold unpainted, but the raised emblems and details make painting easy, ensuring a consistent and uniform appearance.*
Monkey Resin 3 is a high-quality, UV-cured resin designed for strength, impact resistance, and precise detail reproduction. Its low shrinkage rate prevents distortion or loss of fine features while providing a refined surface with stunning details.
These parts will arrive attached to their support structure, ensuring all components remain secure during transportation. Most parts can be easily removed by hand; however, if you soak them in hot tap water for 5 minutes, they will come off much easier. Some attachments may require snippers or a hobby knife for a cleaner detachment. Please make sure you use sharp tools carefully to avoid injury. Once removed, all products are pre-cleaned and ready for primer and paint. Use only super glue to adhere these parts to your models.
Classic MJP is an acrylic material printed using Monkey-Jet technology, which is capable of extremely high detailed parts with a smooth finish. This technique uses wax to support the printing parts to allow for any geometry to be printed without the need of printed supports. Its color may range from amber to clear and parts can be brittle so, handle with care. This material will NOT react with Plastic Glue so, we recommend using Super Glue to adhere these parts to your models.
TufFlex MJP is another Monkey-Jet material with a smooth surface and an extremely high level of detail. However, it's formulated for improved toughness and flexibility to provide a bend-but-don't-break strategy of protection for your models. Thin parts may arrive slightly warped but, can be easily re-shaped by warming them up to be bent back into shape. This can also be an added benefit if you're looking to glue a flat logo onto a curved surface. At room temperature parts will flex but, they can be brittle at much lower temperatures. Use super glue to adhere these parts to your models.
*NOTE: Pop Goes the Monkey is not affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed or approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.
